A faulty battery may damage computers, as well as electrical and other components.
It might potentially be the source of an engine light.
As a result, you can have issues with shifting, performance, codes, and, yes, a “Check Engine” light.
How do you tell whether the warning light is coming on because of a failing battery? And if that’s not the case, what may be the issue?
The Check Engine Light or the Battery Charge Warning Light will illuminate as a result of the fault code produced.
Let’s know can a bad battery cause a check engine light to come on.
Signs Of A Bad Battery
Cars may be created equal, but that does not mean they will remain so. These are some key warning signs of a bad battery.
1. You jumped your battery a lot: It’s a good idea to replace your battery if you’ve had to jump it more than a few times in the last week or month for whatever reason. After being shocked back to life a few times too many times, even a new battery might flake out on you.
2. Your car stinks: It’s possible that your battery has been damaged and is leaking gas. Has it checked out as quickly as possible since sulfuric acid might be seeping and nibbling at other engine parts that aren’t paying attention?
3. The engine cranks but doesn’t turn over: This might be caused by a malfunctioning starter, but it’s more likely caused by a dying battery. Here’s how you can find out:
- To begin, jump your automobile to re-start it.
- Remove the jumper wires after it is going and let your engine run for around 30 minutes to allow the alternator to recharge the battery.
- Now drive back to your house and perform a quick test.
- Turn off the engine, wait a minute, and then restart it.
- Do these two or three times to ensure that you won’t be stranded on your next trip to the supermarket.
If your car starts, the problem is most likely a weak battery rather than a defective starter.
4. Your check engine light is flashing: Your check engine light might be on for a variety of reasons, including defective oxygen or airflow sensor, a worn spark plug, a broken catalytic converter, or a loose gas cap.
A faulty battery might also be to blame, but not for the reasons you would expect. A malfunctioning or undercharged battery will be unable to transfer the appropriate quantity of energy to your vehicle’s computer. The check engine light may illuminate as a result of this.
You may also have a helpful battery warning light on your dashboard if you drive a newer model automobile.
What Else Might the Check Engine Light Be On?
If it’s time for an annual maintenance service, your car’s check engine light may illuminate. If this is the case, a service warning light will most likely illuminate. The majority of the time, though, it is something else.
These are some of the most important reasons:
If you haven’t tightened your gas cap sufficiently, one of the least alarming causes for your check engine light to turn on is that you haven’t tightened it enough.
Because there should be a vacuum seal with the cap when it is tightened, a loose gas cap will set off the check engine light. The check engine light will illuminate if it is loose, damaged, or even shattered.
One of the least worrying causes for your check engine light to illuminate is this.
Your check engine light might turn on for a variety of reasons, one of which is that your catalytic converter is failing. This is a cause for concern since it may be quite costly to replace, and your car depends on it to function.
This is a component of the vehicle’s exhaust system; if you detect a rotten-egg odor as well as a check engine light, it may be on its way out.
I sincerely hope it isn’t this, but it is possible.
This is an important component of the automobile since it determines how much-unburned oxygen is present in the exhaust, and if there is too little or too much, other elements of the engine may be damaged.
A faulty oxygen sensor will always cause a check engine light to illuminate. One of the most typical causes for this to happen when driving is this.
Mass Airflow Sensor
Similarly, the mass airflow sensor in your car’s engine monitors the amount of air entering the engine to ensure that the proper amount of air is mixed with the fuel.
If you don’t obtain enough/the right air/fuel mixture, your engine may stall or take a long time to start.
The check engine light will illuminate if this portion of your automobile breaks because the onboard computer will get a signal that there is a problem with the air and fuel mixture in the engine.
Finally, worn spark plugs or plug wires will cause a check engine light to illuminate, resulting in a check engine warning.
This light will most likely turn on if there is a problem with the ignition system in the engine.
If you’ve driven your car for more than 100,000 miles and haven’t had your plugs changed, it’s time for new plugs and wires. Stalls are another sign that the spark plugs aren’t working properly.
In any case, it’s a good idea to keep an eye on these things.
How Does The Engine Light Work?
For all tasks, the computer within your automobile receives input data from sensors that create signals for fuel and spark supply.
All input signals that potentially impact your emissions are continually monitored by the computer. The computer will also decide if the problem fits the requirements for producing a code.
These codes indicate to whatever section of the automobile is affected by the failure rather than specifying what has failed.
So, it is very important to know what is making your check engine light turn On. It’s the modern blessing that we can act before anything gets worse with our car. That’s why It is very important to know can a battery cause a check engine light.